The short version of GRF(1-29) fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-03-16 and is reviewed periodically as new material appears.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Assessed by visual inspection under ordinary light |
| Primary analytical method | Reversed-phase liquid chromatography | Purity estimated from peak area at 214 nm |
| Confirmatory method | Mass spectrometry | Observed mass compared with calculated value |
| Powder storage temperature | Minus 20 degrees Celsius | Minus 80 for extended archival periods |
| Solution stability | Hours to days at 2 to 8 degrees Celsius | Influenced by pH, buffer, and concentration |
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
Four amino acid substitutions separate the modified backbone from the parent GRF(1-29) sequence. These changes reduce recognition by dipeptidyl peptidase IV and related proteases, extending the interval before degradation. Development work in this area sought longer-acting GHRH analogs for endocrine investigation. Published descriptions treat the substitution set as a defining property of the core sequence, while the albumin-binding linker is described separately as an optional addition to that same backbone.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
Research material is normally supplied as a freeze-dried powder in sealed vials. In that state the peptide is comparatively robust, but prolonged exposure to warmth, moisture, or light accelerates degradation. Storage at minus twenty degrees Celsius or lower, with desiccant and protection from light, is the commonly described practice. Vials should be allowed to reach room temperature before opening to limit condensation on the powder. Moisture uptake during handling is a recognized source of variability in later measurements.
=== Pharmacokinetics === Etifoxine is taken via oral administration. It is rapidly absorbed from the gastrointestinal tract. It is well-absorbed, with a bioavailability of 90%. The time to peak levels of etifoxine is 2 to 3 hours. The plasma protein binding of etifoxine is 88 to 95%. It does not bind to blood cells. The drug is known to cross the placental barrier. Etifoxine is metabolized in the liver into several metabolites. One of these metabolites, diethyletifoxine, is pharmacologically active. The elimination half-life of etifoxine is 6 hours and of diethyletifoxine is almost 20 hours. Etifoxine is eliminated in three phases. The drug is excreted mainly in urine in the form of metabolites. It is also excreted in bile. Only small amounts are excreted unchanged.
== Prognosis == As of 2015, 5-year survival rates for small cell lung cancer (extensive and limited) range between 3.6% and 32.2% for women, and between 2.2% and 24.5% for men. Relative 5-year survival rate for both sexes has increased from 3.6% in 1975 to 6.7% in 2014. In limited-stage disease, the relative 5-year survival rate (both sexes, all races, all ages) is 21.3%; however, women have higher 5-year survival rates, 26.9%, and men have lower survival rates, 21.3%. The prognosis is far grimmer in extensive-stage small-cell lung carcinoma where 5-year relative survival rate (both sexes, all races, all ages) is 2.8%; however, women have higher 5-year survival rates, 3.4%, and men have lower 5-year survival rates, 2.2%. Small-cell carcinoma is very responsive to chemotherapy and radiotherapy, and in particular, regimens based on platinum-containing agents. However, most people with the disease relapse, and median survival remains low. The overall incidence and mortality rates of SCLC in the United States have decreased during the past few decades. Long-term survival of more than 5 years can be achieved with proper treatment. According to the 17th World Conference on Lung Cancer (WCLC), "patients who received chest radiation and prophylactic cranial irradiation along with a mean of five chemotherapy cycles could achieve a median survival of more than 5 years." In some cases, long-term survival of 10+ years is achieved with chemotherapy and radiation alone. A 2023 article stated that the median overall survival is about 1 year, the worst of any lung cancer subtype.
Iron–sulfur clusters occur in many biological systems, often as components of electron transfer proteins. The ferredoxin proteins are the most common Fe–S proteins in nature. They feature either 2Fe–2S or 4Fe–4S centers. They occur in all branches of life. Fe–S clusters can be classified according to their Fe:S stoichiometry [2Fe–2S], [4Fe–3S], [3Fe–4S], and [4Fe–4S]. The [4Fe–4S] clusters occur in two forms: normal ferredoxins and high potential iron proteins (HiPIP). Both adopt cuboidal structures, but they utilize different oxidation states. They are found in all forms of life. The relevant redox couple in all Fe–S proteins is Fe(II)/Fe(III). Many clusters have been synthesized in the laboratory with the formula [Fe4S4(SR)4]2−, which are known for many R substituents, and with many cations. Variations have been prepared including the incomplete cubanes [Fe3S4(SR)3]3−.
Sources: en.wikipedia.org
Shānghán Zábìng Lùn (傷寒雜病論), or The Treatise on Cold Damage and Miscellaneous Diseases, is the first Chinese monograph on diseases by Zhang Zhongjing. The original work is lost, but most of its contents are preserved in two extant works called Shānghán Lùn (傷寒論; "The Treatise on Cold Damage") and Jīnguì Yàolüè (金匱要略; "Essential Prescriptions from the Golden Chamber"). The first work primarily addresses externally triggered conditions while the latter work describes internally generated conditions. Zhang's specialized chapter on xiāo kě is found in Shānghán Lùn and Jīnguì Yàolüè. Nine subsections and nine formulae (herbal remedies) on wasting-thirst were recorded. The text proposed a theory of "three wasting-thirsts": upper- (associated with the lungs), middle- (associated with the stomach), and lower- (associated with the kidneys), all three of which shared excessive urine and thirst as symptoms. This theory was later expanded through the works of Liu Wansu (1120–1200 AD) and Wang Kentang (1549–1613 AD). According to Liu, "lower wasting-thirst" attributed to "kidney-yin deficiency" was associated with sweet urine (glycosuria). This may indicate differentiation akin to modern-day differentiation of diabetes mellitus and diabetes insipidus.
== Medical use == Both T3 and T4 are used to treat thyroid hormone deficiency (hypothyroidism). They are both absorbed well by the stomach, so they can be given orally. Levothyroxine is the chemical name of the manufactured version of T4, which is metabolised more slowly than T3 and hence usually needs only once-daily administration. Natural desiccated thyroid hormones are derived from pig thyroid glands, and are a "natural" hypothyroid treatment containing 20% T3 and traces of T2, T1 and calcitonin. Also available are synthetic combinations of T3/T4 in different ratios (such as liotrix) and pure-T3 medications (INN: liothyronine). Levothyroxine sodium is usually the first course of treatment tried. Some patients report better outcomes with desiccated thyroid hormone; however, this is based on anecdotal evidence, and clinical trials have not shown any benefit over biosynthetic forms. Thyroid tablets are reported to have different effects, which can be attributed to the difference in torsional angles surrounding the reactive site of the molecule. Thyronamines have no medical usages yet, though their use has been proposed for controlled induction of hypothermia, which causes the brain to enter a protective cycle and can be useful in preventing damage during ischemic shock. Synthetic thyroxine was first successfully produced by Charles Robert Harington and George Barger in 1926.
Ropinirole, sold under the brand name Requip among others, is a medication used to treat Parkinson's disease (PD) and restless legs syndrome (RLS). It is taken by mouth. Common side effects include sleepiness, vomiting, and dizziness. Serious side effects may include pathological gambling, hypersexuality, low blood pressure with standing and hallucinations. Use in pregnancy and breastfeeding is of unclear safety. It is a dopamine agonist and works by triggering dopamine D2 receptors. It was approved for medical use in the United States in 1997. It is available as a generic medication. In 2023, it was the 212th most commonly prescribed medication in the United States, with more than 2 million prescriptions.
=== A. tumefaciens === Production of siderophores also exhibited in some plant-infecting bacteria, such as Agrobacterium tumefaciens. The enzyme is controlled by gene cluster agb and the production of 2,3-diDHB dehydrogenase is controlled by the gene agbA. The enzyme AgbA is homologous to the EntA enzyme in E. coli, the same enzyme that produces 2,3-diDHB dehydrogenase.
Sources: en.wikipedia.org
Mass spectrometry establishes whether the observed molecular weight matches the calculated sequence mass. Chromatographic retention and fragment mapping add further confidence about sequence and composition. A single technique alone is rarely treated as sufficient evidence of identity.
Dry powder is markedly more stable than solution and is usually held frozen and desiccated. Room temperature exposure over days degrades it more slowly than most people assume, but long-term integrity favors freezer storage. Light protection is recommended regardless of temperature.
Methods, columns, gradients, and detection wavelengths are not standardized across laboratories. Some figures describe only the main peak area at one wavelength and ignore water, salts, or counter-ions. Without stated conditions, comparing reported percentages across sources is unreliable.
The mass difference from the linker is large enough for routine detection by mass spectrometry. The unconjugated form gives a single sharp signal at its expected weight. Material that has already reacted with albumin shows a much higher mass and a broadened chromatographic peak.